Why does the remote panel not work?

If all of the LED’s are constantly illuminated, the control cable connecting the transmitter and remote panel is hooked up incorrectly.

Refer to Section 5, Transmitter Installation, of the technical manual. Find the INTERCONNECTING WIRE DIAGRAM and the INPUT / OUTPUT TERMINAL BLOCKS diagram.

Next refer to the “Local Radiobeacon Control Unit” in Section 5. This will isolate the problem to the transmitter or the Remote panel.

Refer to the “Remote Radiobeacon Control Panel” in Section 5.

If using the Serial board only (SLP24300):

Ensure the connections on TB3-1, TB3-2, and TB3-3 on the transmitter are connected per the interconnecting wire diagram. TX and RX are reversed on the Remote panel.

If using the Modem board only (SLP33600):

Ensure the jumper J1 is installed ONLY on the Modem board for the Remote Panel.

Remote operation will not work if J1 is installed on both modem boards.